Double Coupler

Used to connect two scaffolding tubes at right angles. These are critical components in the scaffolding structure and must be load bearing to resist both slip and distortion.

Swivel Coupler

Used to connect two scaffolding tubes at any angle. These are key components in the structure and must be load bearing. The body is firmly riveted to permit rotation, still ensures the minimum further movement & maximum rigidity.

Half Swivel Coupler

Pressed Half Swivel clamp by Malmo Steel, this scaffolding fitting is used in fabrication to create components and accessories for use on scaffolding or with 48.3mm tubing.

Join Pin

Used to connect two scaffolding tubes end to end. Fitted internally it expands to apply maximum grip against the wall of the tube. Not suitable for joints where tension can be developed in the tube.

Putlog Coupler

This coupler is designed to secure putlogs and transoms to ledger. It also conforms to the requirements for bracing coupler as it is capable of taking much higher loading than normal putlog couplers.

Sleeve Coupler

Used to join two scaffolding tubes externally end to end. A steel divider located centrally ensures equal insertion of each tube. They can be employed where tension joints are required.

Putlog Adapter

Malmo Steel’s Putlog Head Adaptors are an easy way of converting Scaffolding tube to Putlog tubes for use on Putlog Scaffolds.

Gravlock Coupler

Our Gravlock Coupler are used in pairs to enable Scaffold tube and structures to be anchored to steel beams with upto a 45mm flange capacity.

Swivel Wedge Coupler

End to End Joint Scaffolding Wedge Coupler Rapid Bolt Rapid Pipe Fixed Board Swivel Plank Clamps Bracket Capacity.

Ladder Clamp

Pressed steel scaffold ladder clamp is the traditional ladder clamps in the scaffolding industry. It is lightweight than the double-sided ladder clamps and drop-forged ladder clamps.

The pressed steel ladder clamp is assembled with one long L bolt, one butterfly nut, and a plate. You can adjust the bolt by running the nuts to make it compatible with your scaffold ladder section.