Have any question?
contact@malmosteels.com
+91-8097068300 | +91-9820236307 | +91-22-23485141
Props and Struts
MALMO STEELS Props and Studs provide the ideal and most economical method of support for all kinds of formwork to slabs, beams, walls and columns. They are also invaluable for a wide variety of order application in general building construction and repair work.
Props fully conform to the requirements of British Standard 4074:1982 and have been tested in accordance with British Standard 5507 Part 3:1982.
Props are manufactured from high quality material with a high quality primed and painted finish for long life and are highly resistant to wear and tear.
Props can be used on all types of building construction or for any type of use where an adjustable load bearing member is required.
The high tensile steel pin is located through a slot in the outer section and a hole on the inner section for coarse adjustment. The cast collar located below the pin gives fine adjustment for leveling or striking. The rolled thread ensures no loss of material or strength at this critical point.
Mark I Soldier
The General Purpose wall support system combining high performance with simple, rapid assembly. Great versatility and major cost advantages.
The steel soldier system provides maximum benefits when used with heavy duty ties and steel walings or aluminium beams.
- Strong: Moment of resistance 25.5 kNm
- Right length for the job: Four metric sizes catering for all common formwork heights.
- Tall Forms with fewer ties: End to end joining of soldiers with the joint plate reduces ties to the minimum
- Economic use of walings: Aluminium beams can be used at optimum spacings. There are no pre-set fixing positions.
- Crane Handling: Complete forms can be handled by crane, and lifted clear without dismantling ties.
- Precise Levelling and Plumbing: Integral jacks bring the form level and to plumb without welding or packing.
- Safe Access: Access brackets and handrail posts provide a safe working platform whatever the height.
Corner Soldier
Designed to be used in conjunction with standard soldiers, they simplify the construction of corners. By allowing ties to pass through in both direction, each corner soldier replace two standard soldiers. They permit the tie to be closer to the corner which in turn reduce the loading on external corner.
Steel Waling
The required length of waling can obtained by joining
the waling together using two M16x35mm bolts & nuts
through the holes in end plates.
Waling of different length (1.2m, 2.7m, 3.6m etc.) are
available.
Depth 'A" are available in 100mm, 125mm, 150mm.
Steel Waling Clamp
It is used to fasten the steel waling to the face of
the soldier at any height using one M16x75mm
bolt and nut.
Right Angle Wall Form System
b) Corner Stripping Piece
It is used to support the shutter from the inside face
of the wall corner. It consist of an right angle bend
sheet two square tube & required number of
thread rod & wing nut. While assembling the
plywood of the shutter is placed between the bend
sheet & square tube as shown in the fig..
Assembling of shoring
The shoring bracket is placed through the soldier and bolted with wing nut along with the tie plate, in addition to this another M16x75 bolt & nut is used to fix the bracket across the soldier. To the shoring soldier left & right shoring adaptor is fastened using 8 nos. of M16x35 bolts & nuts one end of this is fitted to shoring bracket using an M10x75 bolt & nut and the other to the adaptor base using an M10x75
bolt & nut.
